Product Information
Fur fabrics can be made from synthetic fibres such as acrylic, polyester, rayon and modacrylic, as well as natural fibres, such as wool, mohair, cotton, silk and alpaca.
Construction
There are several construction types of Fur Fabric. The construction refers to the method of making the fabric. Different constructions have different characteristics; they are as follows:
Sliver Knitted:
This is the most common and economical method of manufacturing Fur Fabric. There is a slight harshness to the backing, as it is latex coated to bind the pile and stabilise the cloth. The knitted cloth has inherent stretchiness. It is well suited to a broad range of uses. Knitted fabric is generally very stable along the cut edge.
Woven:
This style of manufacturing is usually reserved for higher-grade fabrics as it is a more complex and time consuming process. As a consequence, woven Fur Fabrics are generally more expensive. Although structurally of greater strength than knitted Fur Fabrics they require more care to work with. This fabric does not stretch and is unstable when cut and needs to be finished by overlocking or bonding on the cut edge.
Boa:
Some good Fur Fabrics are made with this process as its construction forces the pile to stand more upright. Recommended for experienced users of Fur Fabric as it has a tendency to run if not manufactured correctly. Some Stretchiness.
Velboa:
A very hardy, economical fabric that is made in a variety of finishes. One of the its best features is that it is very easy to maintain. It is a micro knitted fabric and very stable and usually 100% Polyester.
Tufted Pile:
A very basic to low quality Fur Fabric used widely as a low cost lining or utility grade. It has a woven base and does not stretch and is not as widely available as it was in the past.
Characteristics
When selecting Fur Fabrics, there are various attributes which have to be taken into account they are:-
Pile Height:
The height of the pile usually expressed in millimetres or inches.
Density:
The amount of fibres per square centimetre, this usually means the more dense the pile the heavier the fabric is, and the Fur Fabric is less likely to "show teeth", that is the backing becoming visible when the fabric is rolled or folded.
Nap:
The direction that the pile runs. This must be taken into account when cutting patterns, to make sure the nap is running in the correct direction in all segments. Some Fur Fabrics do not have a nap, and some fabrics have a distressed or crushed finish, which means there is no set direction for the nap to run.
Colour:
Colour in Fur Fabrics is a little more complex than in fabrics without a pile as there are several factors that affect the tonings. First, there is the type of fibre used; such as dull or bright, second, whether the fabric is polished or unpolished, third, there can be a mixture of different coloured fibres, fourth, the colour can be affected by the angle or colour of the light as it strikes the surface (refraction) of the Fur Fabric. The colour of Fur Fabric on a roll always looks different to the final made up article.
Width:
The most common width for Fur Fabrics is around the 140 - 160 cms range although in some special cases this can vary.
Jacquard:
A Fur Fabric with an inherant design which is included at the knitting phase of manufacture.
Discharge Print:
A design is applied after the fabric has been manufactured.
Tipped:
A plain Fur fabric is tipped with a dye to give it more interest and simulate certain types of Real Fur.
Blended Fibre:
Different coloured fibres a blended to give a natural look to the Fur Fabric.
Uses For Fur Fabrics
There are numerous uses for Fur Fabrics, the only limitations are the users' imagination. Below is a list of some of the uses.
- APPLIQUE
- BEAN BAGS
- BEDSPREADS
- BED THROWS
- BOAT LINING
- BOOT LINING
- CAR SEAT COVERS
- CAR LINING
- CARAVAN LINING
- CUSHION COVERS
- DASHBOARD COVERS
- DOG COATS
- DRESSING GOWNS
- DRESS TRIMS
- FANCY DRESS OUTFITS
- FLOAT BOOTS
- FLOOR MATS
- FURNITURE UPHOLSTERY
- GOLF CLUB COVERS
- HATS
- HORSE COATS
- INSTRUMENT CASE LINING
- JACKETS
- JACKET LINING
- JACKET TRIMS
- PARCEL SHELF COVERS
- PET BLANKETS
- PET MATS
- POLISHING AND DUSTING MITS
- SADDLE BLANKETS
- SHOE AND SLIPPER INSERTS
- SLEEPING BAG LINERS
- THERMAL VESTS
- THEATRICAL COSTUMES
- THEATRICAL PROPS
- THERMAL JACKETS
- TEDDY BEARS
- TOYS
- UNDER BLANKETS
- VESTS
Care Instructions
Fur Fabric generally has excellent resistance to soiling, a good shake will often dislodge dirt and dust and it is recommended to do this on a regular basis to keep the Fur Fabric looking new. It is also of benefit to regularly brush the pile.
Please refer to care instructions as some Fur Fabrics can only be Dry Cleaned and not washed, if cleaning and washing is advised please refer to the instructions below.
FUR FABRIC IS DRYCLEANABLE (P) 40C Max
HAND WASH AT 40C OR WARM, COLD RINSE
DO NOT RUB OR WRING
DRY IN A THE SHADE AND AWAY FROM ANY HEAT SOURCE
BRUSH WHEN DAMP TO RESTORE PILE (EXCEPT SHERPA)
DO NOT BLEACH
DO NOT IRON
DO NOT STEAM
11001100101000001000100011111111110011001100110011000000110011001010101011110000101010101100110011000000110011001100000011111111
|